500 Sq Ft Garage Floor Kit

✔ Covers up to 500 sq ft — most 2-car garages
✔ Walk on it in 12 hours, park on it in 48
✔ About $3.00 per sq ft — squeegee & step-by-step videos included

A contractor-grade coating system for garages up to 500 square feet. I install epoxy and polyaspartic floors for a living — this is the same system I use on the job, packed for a homeowner who wants to handle the install. You get the coating materials, step-by-step videos, and real phone support from an installer. Questions about your slab or kit size? Call 716-220-5314.

WHAT'S IN THE BOX

• 4.5 gallons slow-setting epoxy base coat
• 80 lbs decorative flakes
• 4 gallons polyaspartic clear coat; non-skid additive (mix in at time of install)
• Squeegee included!
• Step-by-step installation videos

INSTALLATION

1. Measure and inspect — confirm the floor is no more than 500 sq ft; check for cracks, oil, and old coatings.
2. Prep — proper PPE and a hand grinder with a vacuum are required. Clean the surface thoroughly.
3. Repair — fill properly prepared cracks and pits first (Titan Epoxy Crack Filler sold separately).
4. Coat — apply the slow-setting base coat, broadcast the flake, scrape the excess and vacuum, then apply the polyaspartic clear coat with nonskid additive. Follow the included instructions.
5. Cure — walk on it after 12 hours, park on it after 48 hours. Full system done start to finish in 48 hours.
6. NOT INCLUDED: proper PPE, hand grinder with vacuum, and any other tools not listed above. Crack filler sold separately. Ships by ground.