275 Square Foot DIY Garage Floor Kit

✔ Covers up to 275 sq ft — most 1-car garages
✔ Walk on it in 12 hours, park on it in 48
✔ About $2.91 per sq ft — squeegee & step-by-step videos included

A contractor-grade coating system for garages up to 275 square feet. I install epoxy and polyaspartic floors for a living — this is the same system I use on the job, packed for a homeowner who wants to handle the install. You get the coating materials, step-by-step videos, and real phone support from an installer. Questions about your slab or kit size? Call 716-220-5314.

WHAT'S IN THE BOX

• 3 gallons slow-setting epoxy base coat
• 40 lbs decorative flakes
• 2 gallons polyaspartic clear coat; non-skid additive (mix in at time of install)
• Squeegee included!
• Step-by-step installation videos

INSTALLATION

1. Measure and inspect — confirm the floor is no more than 275 sq ft; check for cracks, oil, and old coatings.
2. Prep — proper PPE and a hand grinder with a vacuum are required. Clean the surface thoroughly.
3. Repair — fill properly prepared cracks and pits first (Titan Epoxy Crack Filler sold separately).
4. Coat — apply the slow-setting base coat, broadcast the flake, scrape the excess and vacuum, then apply the polyaspartic clear coat with nonskid additive. Follow the included instructions.
5. Cure — walk on it after 12 hours, park on it after 48 hours. Full system done start to finish in 48 hours.
6. NOT INCLUDED: proper PPE, hand grinder with vacuum, and any other tools not listed above. Crack filler sold separately. Ships by ground.

SAFETY DATA SHEETS (SDS)
Download the Safety Data Sheets for the liquid components in this kit (National Polymers NP707LVP base coat and NP444X polyaspartic top coat, Parts A and B): Safety Data Sheets (PDF). Read all safety information before opening the containers.